Scanner Configuration - Honeywell Scanners

These instructions were followed on a Honeywell EAD51 but may be appropriate for other models.

Follow the details below to set the required scanner settings and then return to the StoreFeeder WMS app to complete the scanner configuration setup.

On the scanner open the Settings app and select Honeywell Settings.

Select Scan Settings then Internal Scanner.

Click the + button in the top right to add a new profile. On the pop up screen choose Select an application. Now select the StoreFeeder app. A new profile will appear on screen. (To delete a profile long press on it to see the delete option.)

Select the new StoreFeeder profile and select Data Processing Settings.

Tick or untick the following values as specified:

Wedge - Off
Launch browser - Off
Scan to intent - On
Launch EZ Config = Off
Data Intent - On

Select Data Intent and set the action and category:

Action - com.sf.barcode.action
Category - com.sf.barcode.category
Package name, class name and extra key can be left empty

Back out of the screens to the profile selection to ensure the values are set and saved.

Go back into the StoreFeeder WMS app.

From the slide in menu select Settings -> On Device Scanner Configuration -> I have updated the settings.

Click "I'm ready to scan" and scan barcode 12345678. If successful a message will appear at the bottom of the screen "Scanner configured successfully".

An ideal test is to go to Products from the slide in main menu and scan a barcode. You should not have to touch the screen or click Search. The barcode scan will populate the search field and perform the search.

If the scan is not successful check in the Data Processing Settings screen displayed above that the prefix and suffix are empty. If these have values in then they will be applied to the scanned barcode which will cause a mismatch when enquiring against StoreFeeder.

If a certain type of barcode is not scanning then check under the new StoreFeeder profile -> Symbology Settings. Ensure each relevant type of barcode is ticked, also note that you can click on the barcode type to select other options such as Send Check Digit. These may need setting.